#Linksys firmware upgrade wrt54g v8.00.8 upgrade#
#Linksys firmware upgrade wrt54g v8.00.8 password#

Linksys WRT54G Reverting Reverting to OEM Firmware from DD-WRT Reset your computer ethernet connection to auto IP and auto DNS.At this point you can choose to put a different build on, depending on what you needs are.When you can again access the dd-wrt webgui using a browser at 192.168.1.1, do another Hard reset or 30/30/30 on the router.When you can access the dd-wrt webgui using a browser at 192.168.1.1, power cycle the router.Try using a different browser as well, to navigate to 192.168.1.1. If you still don't get success, clear your browser cache. If you don't get success, repeat from steps 6 up to this one.

#Linksys firmware upgrade wrt54g v8.00.8 upgrade#

When you get a message that the upgrade is successful, wait FIVE FULL minutes before continuing.Navigate to the folder that you are using, and select dd-wrt.v24-15230_VINT_mini.bin.Go to administration and firmware upgrade.

#Linksys firmware upgrade wrt54g v8.00.8 password#

Leave the username blank and enter 'admin' as the password.

If you see management mode, power cycle the router again. You should open the linksys webgui and NOT a page that says Management Mode.

Open your browser to 192.168.1.1 by putting that in the browser address window of your browser.

Power cycle the router (uplug the power from the router for 30 seconds and then plug it back in).

Turn your firewall and any wireless computer connections OFF. Nothing should be connected to your computer or the router except the lan cable between them.

Connect the lan cable from your computer to a LAN port of your router.

Set a static IP on your computer to 192.168.1.7.

Do a Hard reset or 30/30/30 on the router according to note 1 of the peacock announcement (30/30/30).

Read the peacock announcement found here:.

WARNING: Requires K2.4 for DD-WRT, Do not flash anything else! NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power.ДЇor DD-WRT, These units seems to run more stable on the VINT builds.

WRT54G v2.0 brick just after hard reset.

Linksys WRT54Gxx page on the DD-WRT wiki.

For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.ДЄdditional FCC ID of Q87-HGA7T-1 (Linksys HGA7T, high gain antennas)